Extremely Simple Technique To Fix Vehicle Speakers
There are many problems that might arise in the speaker system. The problem may be detected when there is noise, rattling sound, popping sound or a hissing noise. The other problem could be that one speaker might be fully dead and the music might not be playing in one speaker. When such signs are shown by the speakers they need a service or might also need a replacement. When the speakers have to fixed, they must first be opened and then the problem must be detected before fixing it. But how to fix a car stereo speakers without any professional help? This article will provide some basic tips for this.
Before taking a look at detailed stepwise procedure here is a list of things we need to do the job. They are speakers for replacement, screw driver, glue, battery usually nine volts and manual of car. First step is to locate the speaker that needs repair or replacement. To do this we take the help of car manual. They can be in dash board , mounted on door of the car or can be located at the deck of the car on rear side.
With the help of your car`s manual first locate the position of the speakers. The speakers will either be mounted on the door or at the rear end of the vehicle. Now check whether there are any screws holding the speakers. Mostly there will be a grill protecting the speakers. In such a case remove the screws holding the grill. But if there are no screws present then try to pry the grill with the help of a butter-knife or with the help of a flat-head screw driver.
Sometimes the grill might be tougher to remove. Then, the pads of the dashboard or even the panel of the door can be removed. The manual can be followed to remove these. The pads of the dashboard can be removed with all its screws kept beside. After the grill is removed, the speaker can be detached. To do this, the screws that hold the speaker in place are removed.
To check whether the speakers are working properly, tighten the speaker`s butt connector. Now check whether there are any short behaviors by connecting the speakers to a 9-volt battery after disconnecting the speaker from the car battery. if there is a ‘pop’ or a ‘thump’ sound then the speaker is fine. Next check whether there is any warping present. Simple cracks can be fixed by using some special adhesives. However if the cracks are severe then it is probably a suitable time for replacing the speakers.
Here is a list of probable causes for damage of speakers. They are magnetic coil damage, short circuit, fuse damage and cracks in the cone. Lets look how to tackle each of these. Fuses associated with speakers are in voice coil and in the wiring. We can see them directly . If damaged just replace them with new ones and speakers will start working.
Next to deal with cracks use common adhesives available in the market like gorilla glue. These adhesives are not only durable but are also of light weight. Warping if its severe then there is not other option but to replace the speaker with a new one. Wires may be short circuited. This can be found out if new speaker after replacement also does not work. In that case speaker wiring has to be changed. After checking out for all this still if there is problem with speaker then the cause must be coil damage or sometimes even the magnet. If that is the case speakers have to be changed and cannot be repaired. Be smart in finding the correct replacement. Make a check of size and power of new speaker.
This is how to fix a car stereo speakers when the exact problem is not known.
Looking to find the best deal on , then visit www.powernetshop.at to find the best advice on for you.
Leave a comment